CORRECTED: Interpretation of GRID-terrain along line object for Long Section and Cross Section functions in Novapoint Base.
IMPROVED: Road model result objects is no longer always set to phase “Designed” even though phase “Existing” is chosen.
CORRECTED: Period “.” in road model filename made the road calculation fail.
CORRECTED: New alignment was not used when “Pick Angular Point” was used to replace an existing alingment.
IMPROVED: Export of road model to .GEN from non-reserved tasks no longer give Read-only files. This will eliminate problems regarding this when reading the file in to GEMINI software.
CORRECTED: Export to IND with special caracters (ex. ÆØÅ) did not create a file.
IMPROVED: Crossfall calculation with broken shoulder kan now be established on all 2-surfaces for shoulder.
IMPROVED: Crossfall calculations changed to avoid quick changes in the crossfall in cases where the alignment does not give room for correct crossfall calculations.
IMPROVED: Widening in areas where there isn't room for normal widening transitions to 0,000m width (ex. arc-line-arc combination where the line is to short for normal transitions it will do a linear transition between the widths between the curves).
CORRECTED: Storing of alignment from surface edge if the road model filenames included period “.” in the filename before “.GEN”.
CORRECTED: Crash when the catalog-file was missing (previously demanded Reset User Settings or manual work to fix)
CORRECTED: Possible to change the description to drawing setup after it is generated.
IMPROVED: Drawing speed for alignments in the Quadrimodel.
CORRECTED: Crash when the catalog-file was missing (previously demanded Reset User Settings or manual work to fix)
CORRECTED: Crash when the catalog-file was missing (previously demanded Reset User Settings or manual work to fix)
IMPROVED/CORRECTED: Errors connected to the dialog or result when drawing cross-sections to PDF or DWG. General improvements.
CORRECTED: Drawing 3D-surfaces to layername with <TaskName>.
CORRECTED: Updating or drawing road model again made the drawing disappear as if one wanted to remove/delete the road model drawout.
